Hava Ceketli CO2 İnkübatör 140 DERECEDE STERİLİZASYON





Thermo Scientific 8000 DH
 C02 inkübatörleri, hava ceketlidir.

> Kolay kullanıma sahip olan, güvenli ve kendini kanıtlamış olan sterilize sistemi ile kabin içinde yaşayan tüm mikrobiyal yaşamı yok eder.

> Yüksek sıcaklıkta otomatik temizleme döngüsü sterilize işlemini ideal olarak bir gece de yapar ve ortamın temizliğini garanti eder.

> Thermo Scientific 8000 DH C02 inkübatörleri çok hafiftir ve alta bulunan dönen ayaklarla istenilen yere konulabilir.

> Doğrudan hava akışı ve kabinin ısıtılması ideal kültür ortamının en uygun homojenlikle devam ettirilmesini sağlar.

> Sterilize döngüsü boyunca, bu sistem aynı zamanda inkübatör kabininin tüm kirlerin yok edilmesini sağlamaktadır.


> Maksimum 184 lt iç hacme sahiptir.

♦ 140 derecede sterilizasyon özelliği ile...

Temperature  
Control ±0.1 °C
Range 5 °C above ambient to 50 °C (122 F)
Uniformity  ±0.3 °C @ 37 °C (98.6 F)
Tracking Alarm User-programmable high/low
Overtemperature  
Sensor Precision thermistor
Controller 0.1 °C
Setability Shuts off heat
Temperature Safety  
Sensor Precision thermistor
Controller Independent analog electronic
CO2  
CO2 Control  Better than ±0.1 %
CO2 Range   0-20 %
Inlet Pressure 15 PSIG (1.0 bar)
Sensor T/C or IR
Readability & Setability 0.1 %
Tracking Alarm User-programmable high/low
Humidity  
RH  Ambient to 95 % @ 37 °C (98.6 F)
Humidity Pan  3.2 qt. (3.0 liters) standard
Display (opt.) In 1% increments
Fittings  
Access Port with filter 1.3" (3.3 cm) with removable silicone plug
CO2 Inlet 1/4" hose (barbed)


Direct Heat

High Temperature Uniformity Directed airflow and direct chamber heating maintain optimum uniformity for an ideal culturing environment. During the sterilization cycle, the same system ensures that your incubator’s entire chamber is sterilized – all contamination is eliminated.
                                                                                                                                      

Direct Heat Sterilization Cycle – 120 minutes at 140°C – ensures the elimination of all microorganisms and fungal spores from every incubator surface (ANSI/AAMI/ISO 11134). This claim has been validated with suspensions from B. subtilis spores calibrated for dry heat processes, because these are most resistant against dry heat sterilization and therefore the recommended indicator organism (U.S. Pharmacopoeia, ch. 1035). All spores applied to the different surfaces of the incubator – chamber wall (stainless steel), door (glass) and door gasket (tempered silicone), have been reliably eliminated with the sterilization cycle after 120 minutes at 140°C.

Diğer Ürünler